| EZ Rail In Ground Installation Method
Are the tops of your steps more than 16” above the ground? You will need longer posts. The hand rail must be 2’ 10’’ above the step and 1’ into the ground. Contact us for custom order! |
Attach the posts of your EZ Rail using the hardware provided, but don’t tighten completely. Have an assistant hold the rail level while you mark where the holes for your post should be dug. Tip: Split the difference between the top and bottom steps so the posts are evenly spaced. The rail looks best if the posts are centered next to a step. |
Dig a hole a foot deep for each post. Depth is important. If your posts are not deep enough, the railing can not support the stress of a person loosing his balance. Serious injury could occur! |
|
|
Step 4: Position your Posts. Use a level to set your posts vertically. You will need to check two perpendicular sides of each post, to ensure it’s not leaning forward or sideways. You may need to use clamps and supports to hold this position until the cement hardens. |
Mix concrete according to directions, and pour into the holes. Be careful to make sure your rail stays at the proper height and that the posts are straight up and down as the cement hardens. |
|
Your EZ Rail comes sprayed with a gray primer. This must be covered with rust-protecting paint. Do this before or after installation. (We recommend painting after installation, as it is easy to nick the paint while installing.) Touch up any nicks caused by shipping and installation. Maintain your rail in the future by sanding down rust spots, and repainting. This will help your railing stay beautiful for years to come. For questions call 412-221-4488 7:00 a.m. to 3:00 p.m. EST or email This e-mail address is being protected from spambots. You need JavaScript enabled to view it |



Step 4: Position your Posts.



